Magnetic Straight Edge Guide with On/Off Switches for Plasma

September 19,2024

Just lay down the material you want to cut on your steel work bench and place the magnetic straight edge on top of it with the magnetic switches in the off position. When you have the straight edge positioned exactly where you want it, Just flip the switches to the on position and your ready to start your cut.

Just lay down the material you want to cut on your steel work bench and place the magnetic straight edge on top of it with the magnetic switches in

Magnetic Straight Edge Guide with On/Off Switches for Plasma Cutting

Multi-Use Angle Burning Guide – Flange Wizard

Walker Partners Magnetic straight-edge guide with on/off switches for plasma cutting

Magnetic Starter Single Phase, 5 hp Motor Starter, 34 amp Starter Switch, 230 v Air Compressor

Diy Magnetic Plasma Cutter Guide Easy As

The plasma cutter Offset Blocks allow you to make precise straight cuts with your hand-held torch They have two sides and are offset according to the

Offset Blocks - 2pc. for Plasma Cutter Straight Edge/guide - .380 - Red

PT-32 PLASMA ARC CUTTING TORCH

Plasma Cutting Compass, Cutting Torch Circle Roller Guide Wheel P80 Cutter Circular Gauge Machine Gun Length Approx 50cm for Metal

Plasma Cutting Guide In Plasma Cutters for sale

Magnetic Cutting Torch Guide - On/Off Magnet MSG230

5 x 10 Inch Standard Pole Permanent Magnetic Chuck, use with EDM, Surface Grinder, Tool Grinders ID 16207

Plasma angle cutting guide is versatile and easy-to-use plasma and oxyfuel cutting guide is designed for accurate hand cuts of angles and square

Hypertherm 017041 Torch Guide, Angle Cutting Guide Magnetic

A versatile and easy-to-use plasma and oxyfuel cutting guide for accurate hand cuts of straight edges Two magnetic blocks with a 24 (61 cm) straight

Hypertherm 017042 Magnetic Straight Edge

Now you can easily make cuts where a clamp won't reach. Each Mag Holder has 6 lbs. of pull strength and 3 lbs. of shear strength. This allows easy

Magnetic Plasma Guide Holder 2 pc. - for Plasma Stencils and Straight Edge

Linear Track Makes Plasma Cuts Neat And Simple